Compa Ratio: Meaning, Formula & Calculation Example
Updated 4 min read
Definition
Compa ratio, short for comparison ratio, is an employee’s pay divided by the midpoint of the pay range for their grade.
Listen to this article
What Is Compa Ratio?
Two people can sit in the same pay range and still be paid very differently, and one number shows where each of them stands.
Compa ratio, short for comparison ratio, is an employee’s pay divided by the midpoint of the pay range for their grade. A result of 1.00 means pay sits at the midpoint. No law requires it, but it helps in pay reviews and checks under the Code on Wages, 2019, which bars gender-based pay differences for the same or similar work.
Compa Ratio Formula and What It Shows
The formula compares the person’s pay with the midpoint of their grade:
Compa ratio = actual pay ÷ midpoint of the range, where the midpoint is (minimum + maximum) ÷ 2.
- Below 1.00: paid under the midpoint, common for new joiners or people still learning the role
- At 1.00: paid at the midpoint, usually set at the going rate for someone fully settled in the job
- Above 1.00: paid over the midpoint, usually after long service or strong performance
Use the same pay measure the range was built on, such as fixed monthly gross. For a team, divide total pay by the total of their midpoints. A Bengaluru IT firm or a Chennai auto parts factory can check each grade this way, and a grade averaging well under 1.00 pays below its own midpoint.
Compa Ratio vs Range Penetration
| Aspect | Compa ratio | Range penetration |
|---|---|---|
| Compares | Pay with the midpoint | Pay with the whole range |
| Formula | Pay ÷ midpoint | (Pay − minimum) ÷ (maximum − minimum) |
| Answers | Above or below the going rate? | How far up the range? |
Both use the same range, so they get mixed up. One compares pay with the going rate; the other shows how much room is left. A nurse on ₹37,290 in the example below has a ratio of 1.13 but is 93% of the way up, so any raise above about 2% would pass the top.
Compa Ratio Example
A private hospital in Pune (an example) reviews its staff nurse grade before the April 2027 appraisals. The grade runs from ₹28,000 to ₹38,000 a month, so the midpoint is ₹33,000. HR works out each nurse’s ratio before it decides any raises.
| Nurse | Monthly pay | Ratio |
|---|---|---|
| Nurse A | ₹29,370 | 0.89 |
| Nurse B | ₹34,650 | 1.05 |
| Nurse C | ₹37,290 | 1.13 |
Note: this is an invented example for illustration only. The hospital, the nurses and the figures are made up.
Nurse A joined in 2025 and is rated well, so she gets a 10% raise to ₹32,307, a ratio of 0.98. Nurse B, at 1.05, gets 6%. Nurse C is close to the maximum, so she gets a one-time payment instead of a raise, since anything above about 2% would push her past it.
Each new figure then has to reach the payslip from the month the raise takes effect. If an April raise misses April’s payroll, the difference becomes arrears to pay later. In Attendo (formerly Petpooja Payroll), the revised figure goes into the employee’s salary structure, which the next payroll run uses.
Using the Ratio to Check Fair Pay
Sorted by group, the ratio can also show unequal pay. If women average 0.91 and men doing similar work average 1.04, with similar skill, effort and responsibility, look for a reason other than gender. Section 3 of the Code on Wages bars gender-based pay differences, and our gender pay audit template sets out the check.
A healthy ratio can hide a range set too low. Check each grade’s minimum against the notified minimum wage under section 5 whenever the rates are revised. That test uses wages as the Code defines them, which leave out house rent allowance, so a gross figure can look safe when it is not.

